MARK 1
- .177 cal., SP, SS, BA, 9.25 in barrel, nickel finish, one-piece grip frame and breech block with black hard rubber grip plates, front sight sleeves muzzle, rear sight is a notch on the bolt handle, cocking plunger in front of compression...
TITAN (DISC.)
Note there are a considerable number of variations from these basic models; variations which do not seem to merit model level status at this time. These model numbers have been proposed by noted airgun researcher John Atkins (Airgun Editor, Airgunner Magazine) and do not represent model designations of the maker. Numbers on guns probably are not serial numbers. The authors and publisher wish to express their appreciation to John Atkins and the late Ingvar Alm for their valuable assistance with the following information in this section of the Blue Book of Airguns.
Previous trademark of air pistols patented and probably manufactured by Frank Clarke located in Birmingham, England circa 1916-1926.
TITAN (DISC.) Airguns Models
MARK 2
.177 cal., SP, SS, similar to Mark 1, except has iron grip frame and air chamber cast in one piece, no grip plates, cocked by plunger rod (apparently removable) from rear, bolt attached to the barrel, barrel slides forward to load, nickel p...
MARK 3
.177 cal., SP, SS, similar to Mark 1 and Mark 2, except has one-piece cast iron compression tube and vertical grip frame, barrel bands with rear band acting as sight, front sight on barrel, breech block rotated counter-clockwise for loading...
MARK 4
.177 cal., SP, SS, similar to Mark 3, except more streamlined and longer barrel, pinned cap at forward end allows forward removal of mainspring, barrel support lugs cast into body tube, vertical grip frame with checkered wood grip plates in...
MARK 5
- .177 cal., SP, SS, similar to Mark 4, except has 7 in. barrel, mainspring removes from breech end, front sight cast on top of front barrel band, checkered hard rubber grips, roll stamped LH side compression chamber 'THE "TITAN"...
MARK 6
- .177 cal., SP, SS, similar to Mark 5, except has trigger sear adj. screw through rear of trigger guard, four pins mounting trigger and guard, roll stamped LH side 'THE "TITAN" AIR PISTOL' over 'PATENT 110999/17', approx. 1.8 lbs...
MARK 7
- .177 cal., SP, SS, similar to Mark 6, except without trigger sear adj. screw, internal grip safety disengaged when cocking rod is depressed into frame slot, checkered hard rubber grip with "T" inside of a circle molded on top ha...